RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: LimitDwn
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: RC Jets
10-12-2020, 02:30 PM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

I full understand the time it takes to build a...

I full understand the time it takes to build a high quality jet, an yes I'am a slow builder as well, it usually takes me 6 to 9 months for a single build. A couple of pictures from my TI Mini build,
Forum: RC Jets
10-12-2020, 02:20 PM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

Have a look at the attached picture, I had one in...

Have a look at the attached picture, I had one in mine but did not want to use it. So I made a mount to fit a mini servo. I used one of the aluminum servo mounts for a large servo and then cut and...
Forum: RC Jets
04-02-2019, 03:34 AM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

Mine was about 6 weeks, but I ordered when there...

Mine was about 6 weeks, but I ordered when there were no holidays to contend with, as for notice, NOT. It just showed up and this was delivered to a PO Box. One thing that they did get right was...
Forum: RC Jets
01-21-2019, 08:17 AM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

Something to Check

Guys,

I have started to build my TI and I came across something that you may want to check. When I build, I build in layers starting at the lowest part of the fuse and working up and sometimes in...
Forum: RC Jets
01-21-2019, 05:48 AM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

Stan, great news, and I'm sure that you will not...

Stan, great news, and I'm sure that you will not be the only person that this will happen to, all this is great info if this happens to the next person.

Robert
Forum: RC Jets
01-20-2019, 12:19 PM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

Stan, Yes you would be cutting the bolt...

Stan,

Yes you would be cutting the bolt between the upper and lower part of the clamp. There is a little more than 1/16" gap between the upper and lower part of the clamp and the cutting disk is...
Forum: RC Jets
01-20-2019, 10:30 AM
Replies: 1,631
Views: 335,429
Posted By LimitDwn

Stan- Based on my years of experience in...

Stan-

Based on my years of experience in woodworking, I would suggest NOT using the vibrating cutter as it very aggressive and has a tendency to jump around, especially on metal. Instead, I would...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.