RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Edhamp
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: Gas Engines
02-15-2024, 05:00 AM
Replies: 303
Views: 54,582
Posted By Edhamp

I ve had exactly the same experience with this...

I ve had exactly the same experience with this engine, after many days and hours trying, following the advice of all the experts, setting the needles etc, Walbro carb aka MorrisMiniMotors, pump, no...
Forum: Gas Engines
08-02-2023, 08:54 AM
Replies: 303
Views: 54,582
Posted By Edhamp

Thanks. Already did so but no luck. He referred...

Thanks. Already did so but no luck. He referred me back to Morris Mini Motors but cannot order from them as they do not accept card payment or PayPal at the moment. That does not work for me.
Forum: Gas Engines
08-02-2023, 05:13 AM
Replies: 303
Views: 54,582
Posted By Edhamp

Does anyone know where else I can buy carb...

Does anyone know where else I can buy carb conversion kits apart from Morris Mini motors? Thanks
Forum: Gas Engines
08-02-2023, 01:30 AM
Replies: 303
Views: 54,582
Posted By Edhamp

Thanks for the reply and helpfull comments...

Thanks for the reply and helpfull comments partshunt. Given between us you have experienced problems getting the engine to rev much above 5000 rpm and I cannot get it to run below 2500 rpm on the...
Forum: Gas Engines
08-01-2023, 12:15 PM
Replies: 303
Views: 54,582
Posted By Edhamp

Hi Guys, JUst got a UMS 7-50 to go into...

Hi Guys,


JUst got a UMS 7-50 to go into Seagull Skyraider (cowl has been slightly enlarged to get it to fit).

I m running-in the engine. Starts OK, high speed needle works fine, good pickup...
Forum: Gas Engines
11-02-2022, 02:56 PM
Replies: 303
Views: 54,582
Posted By Edhamp

Hi, Just got a new 7-50 for a Skyraider. Just...

Hi, Just got a new 7-50 for a Skyraider. Just fits cowl but is tight and a prop shaft extension would help. I may get away with a 1/4" spacer bush and using either 20x8 or 18x8 props to start with....
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Manage Preferences - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.